Linux的雏形，也就是Linux的创始人公布的最初代码。 现在各种分析Linux的书太多了，但对于初学者来说都过于复杂，难以理解，这个最初版本相对来说要简单多...

Bootloader(Vivi)源代码分析 ----基于S3C2410处理器-Bootloader (Vivi) source code analysis-based S3C2410 Processor

32位寄存器的VHDL的原代码下载,COOLCOOLCOOL-32-bit register of the original VHDL code download, COOLCOOLCOOL

电路实验收集的好东西，拿出来给大家分享了，多多支持啊-Experimental circuit of the good things to collect, share out to everyone, and a lot of support ah

这是帮别人做的程序，模拟操作系统中进程控制块（包括多道系统中动态优先级进程调度和动态内存分配），用tc2.0做的，带有图形界面和简陋的控制台。现在把源代码贴出来。-This to help procedure that others make, simulation operating system process control piece (whether including many dishes of system dynamic PRI process dispatcher and dynamic memory assign), use tc2. 0 ones that make, there are figure interfaces and simple and crude control cabinets. Stick the source code out now

S3C2410上非操作系统的usbHost程序，可以不用操作系统读写U盘等-S3C2410 on non-operating system usbHost procedures, you can not read and write operating systems, such as U Disk

C++编写的一个操作系统程序-prepared an operating system procedures

采用静态优先数的方法，编写一进程调度程序模拟程序，进程状态为就绪、运行、阻塞三种。模拟程序只对你所设置的“虚拟PCB”进行相应的调度模拟操作，即每发生“调度”时，显示出当前“PCB名字”、优先数、运行时间等，而不需要对系统中真正的PCB等数据进行修改。-priority number using the static method, the preparation process of scheduling a process simulation program, the process in place for the state, running, blocking three.PCBPCBPCB

分析了IDE接口硬盘控制寄存器模型；论述了IDE接口硬盘的读写几项技术；给出了设计硬盘克 隆软件的思想和方法，方法针对硬盘物理扇区进行读写，与硬盘上安装的具体操作系统的类型无关，并与硬 盘驱动器的物理结构无关。-Analysis of the IDE hard disk interface control register model discusses the IDE interface hard disk read and write a number of technologies gives the design the hard disk cloning software, the ideas and methods, methods for the physical sector of the hard disk read and write, and the hard disk is installed on specific operations the type of system has nothing to do with the physical structure of the hard drive has nothing to do.

一个实模式下显示内存内容的例子 nasm编译 @ CPU及微机基本硬件的使用-A real model of examples show the contents of memory to compile NASM @ CPU and computer use of basic hardware

rtems一个相当优秀的开源嵌入式操作系统,用winrar解压后将扩展名后的_去掉，再解压就行-RTEMS a very good open-source embedded operating system, with WinRAR decompression after the extension removed _ and then decompress on the line