扩频接收机设计实例,vhdly源代码!大家下载下来吧,在ise中调试通过...

RS,Viterbi,Sequence 编解码C源代码-RS, Viterbi, Sequence codec C source code

采用全波电磁仿真软件，仿真设计了超宽带缝隙结构的平面等角螺旋天线和阿基米德螺旋天线，两种天线都采用同轴电缆直接馈电的方式。(this paper proposes an idea about experimental teaching mode reforming of microwave technology and antenna courses by introducing the full wave elect.)

matlab rfid仿真，type a 仅供参考。(matlab rfid)

RFID连接Arduino然后用串口监视显示测得数据(How to use RFID connect to Arduino.Then use serial monitor show the detected data in PC.)

无线收发程序，用avr单片机控制24l01芯片 -Wireless transceiver procedures, using avr SCM chip 24l01

2.4G，RFID电子标签程序，这是经过测试可以用的nrf24L01接收发送程序，应用环境是MSP430F149(2.4G, RFID tag program, which is tested can be used to send program nrf24L01 receiving the application environment is the MSP430F149)

rfid heathcare book-rfid heathcare book

rfid系统的matlabsimulink建模及特性分析(rfid systems matlabsimulink Modeling and Analysis)

RFID Inventory Project Table of Contents

射频和无线技术入门(第2版)，carl J. Weisman著。刘志华 徐红艳 李萍译。清华大学出版社出版。清晰。(RF and Wireless Technology Introduction (2nd edition), carl J. Weisman forward. Liu Zhihua Xu Hongyan Li Ping translation. Tsinghua University Publishing House. Clear.)