用C51编写的源程序清单（由实验板运行通过）包含器件配置文件.闹时启/停子函数.走时函数.定时器T0 5mS初始化.扫描按键子函数.延时子函数等整个工程源代码...

这是一个接收单片机数据的软件,通过对接收的数据分析来显示相应的LED.目前只能显示一个LED,有时间会全部做好的,目前接收到的数据为0A0B0C,也就是从单片机发出来的数据为10,11,12,单片机的程序是a-This is a single-chip microcomputer software to receive, through the analysis of data received to display the corresponding LED. Currently only display a LED, will all have time to do a good job of currently received data 0A0B0C, that is, from a single machine sent to the data for 10,11,12, SCM process is a

MT8888芯片的C51读写程序-MT8888 chip C51 literacy procedures

本文只有程序，无电路图，是基于单片机控制的线性数字稳压电源-In this paper, only the procedures, no circuit diagram is based on the number of single-chip control of linear regulated power supply

采用USB单片机开发的TMS320C6701/C6201系统的在线升级模块，包含相应的SCH和PCB，以及相应的源代码，注释比较详细。-The use of USB single-chip system developed TMS320C6701/C6201 online upgrade module that contains the corresponding SCH and PCB, and the corresponding source code, more detailed notes.

学习51单片机必备的一些C语言基础知识，对C语言不熟悉的朋友会有一定的帮助-51 Singlechip necessary to learn some basic knowledge of C language, on the C language are not familiar with our friends will help

用L298作为驱动器，控制两相混合式步进电机。 按键从上至下分别为减速，加速，正转，反转，停止。 具体参数还没有设定过。速度有些慢，加速按2下有效，然后就不能再快了。 转速输出是按照最小系统版的数码管写的。电路图里太麻烦就没画了。-Using L298 as the drive to control two-phase hybrid stepping motor. Buttons from top to bottom respectively, deceleration, acceleration, are being transferred, reverse, stop. Specific parameters have not yet been set. Some of the slow speed, speed up by 2, effectively, and then can not be faster. Speed output is in accordance with the minimum system version of the digital tube wrote. Circuit where not too much trouble drew.

sed1335液晶显示控制器应用技术资料，应用广泛，必备工具。-sed1335 LCD controller information technology, widespread use, essential tools.

PWM example.which is done using Makro C PIC programming IDE.

MAX7219驱动例程，工程内还有DS1302等驱动代码，是学习写驱动不错的工程。-MAX7219-driven routines, engineering, etc. There are DS1302 driver code, is to learn to write good works driver.