Fujitsu MCU and LIN

本程序成功实现温度的采集功能，单片机通过单总线的方式来访问温度传感器的存储区，从而得到温度值

一些嵌入式操作系统的官方说明书--Some official manuals about embedded operating systems.

TI原产TMS320C6713DSK开发板中CPLD的内容源码，对自己做开发板非常具有参考价值

利用模糊控制系统实现水浴温度和速度的自动控制。

数字温度计 单片及课程设计 C 语言设计1-Single-chip digital thermometer and curriculum design C Language Design 1

pci驱动开发介绍，从简单开始，很容易掌握-Introduction pci-driven development, from simple to start, it is easy to grasp

　以三星的2410芯片作为CUP的开发板，通过编写低层驱动，实现在WINCE环境下进行ADC采集并绘出图形。-Samsung 2410 chip with CUP as a development board, through the preparation of low-level driver to achieve the WINCE environments ADC capture and draw the graph.

适用于at91sam9260ek编程。初始化USB端口主机或设备接口将有助于配置和存储SDRAM或compact flash或NAND flash

改写的U-boot for s3c4510 (注意此源码是在windows下压缩了)。 1、支持串口下载，ftp下载。 2、flash操作。 3、总之，u-boot是一个可移植在多种单片机上的bootloader。其功能特别强大。 4、本移植针对s3C4510,flash 1片2M　16位宽度，SDRAM 1片16M　16宽度。网络物理层RTL8019。 5、你可以直接windows解压后，把u-boot.bin烧写到FLASH的0x0,或放到redhat 9下重新make.-rewrite the U-boot for Porting (Note that this source is under pressure in windows a shrinking). A support serial download, ftp download. 2, flash operation. 3, in short, u-boot is a portable in a variety of microcontroller on the Bootloader. Its function was particularly strong. 4, the transplant against s3C4510, flash a 2M 16 width, 16M SDRAM a width of 16. RTL8019 network physical layer. 5, you can directly windows unpacked, put u-boot.bin burning FLASH to the 0x0, redhat 9 or put under re-make.

我用一个按钮和控制 led 当按钮=1导致打开布顿=0导致关闭