我自己编的一个一位数码管减计数的学习程序，在pic16f73已经验证了。...

为LCD12232F写得驱动程序，主控核为凌阳SPCE061A，连接方式请根据程序中的注释连接，工程可下载直接使用。-LCD12232F written for the driver to master the nuclear Sunplus SPCE061A, connections in accordance with the procedures of the Notes connection, works can be downloaded directly used.

Loops back EP2OUT to EP6IN and EP4OUT to EP8IN.

CAN总线控制，SJA1000基本操作，keilC51开发环境-CAN bus control, SJA1000 basic operation, keilC51 Development Environment

常用的液晶屏LCM12864的演示程序，使用汇编语言编写-common LCD LCM12864 the demo program, written in assembly language

16乘2的液晶显示屏演示程序，对于研究液晶屏很有帮助

针对于AT24CXX的IIC读、写操作的源码。-For the IIC in AT24CXX read and write operations source.

单片机C语言 学习单片机C的好例子 -Singlechip C Language Learning Singlechip a good example of C

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4, 每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

这个范例说明如何使用8051 的Port 1连接到四颗七段显示器，PORT 0的低4位分别控制这四颗共阳七段显示器，让四颗共阳七段显示器使用扫描的方式轮流-This example shows how to use the 8051 Port 1 connected to four seven-segment display, PORT 0, low 4, respectively to control the total of four seven-segment display yang, so that a total of four seven-segment display yang way of using the scan rotation

深入了解内存-Deeper understanding of memory