dsp2812采用规则采样法得到spwm波

针对ADSP-BF533开发板的例程，关于ISP1161，可以直接引用，软件开发环境为VisualDSP-For ADSP-BF533 development board of the routine, on the ISP1161, can be directly quoted, software development environment for VisualDSP

录DEC6713的UART串口的测试程序。需要将板上的跳针JP3、JP5各自短接，将UART通道A 和通道B均配置为RS232方式。-Recorded in the UART serial DEC6713 test procedures. Need to jump on-board pin of JP3, JP5 their shorted to UART channel A and channel B are configured for RS232 mode.

依据网上流传的瑞泰dsp2812评估板的ad转换程序核心部分

bootloader for TMS320C6713

根据FFT的原理和公式，编写了TMS320c5509adsp的FFT程序：首先，2N点实数的连续输入成为“进包”，其次，N点的FFT被连续执行，最后作为结果产生的N点的合成输出是”打开“成为最初的与DFFT想符合的2N点输入。

dsp浮点数转化为定点数的方法，其格式为Qm.n,通过宏定义可以改变格式，位数也可以增大到32位-dsp float into the set points, its format Qm.n. Acer by definition can change the format, the median can be increased to 32

通信工程学院：冯文江教授给研究生用的书，包括大量基础理论知识、基本概念等内 容，要求工学硕士在本门课程学习中，注重通信信号处理的新结构、新算法、新思想、新理论；而工程硕士更多的应结合工作实践，应用这些典型的方法分析和解决实际问题-Institute of Communications Engineering: Professor Feng Wenjiang to graduate with the book, including a large number of basic theoretical knowledge, basic concepts such as contents, requirements engineering master" s degree course in this study, focusing on the new structure of communication signal processing, the new algorithm, new ideas, new theories and Master of Engineering more work experience should be combined with the application of these typical methods for analyzing and solving practical problems

TI C6000 的 EPPROM的使用方法，初学者必读-the EPPROM way to use mandatory beginners

2000系列，TMS320LF2407开发板原理图-2000 series, TMS320LF2407 development board schematics

《DSP嵌入式系统开发典型案例》此书的源代码，很值得一看。- DSP embedded system development a typical case of the book s source code, it is worth a visit.