基于S3C2440，改变输入，实现AD转换，并通过串口打印出来。

嵌入式ARM7――PLC2124实例开发，用Keil uVision3软件编写原程序再通过，软件PROTEUS对ARM7――PLC2124进行联合虚拟仿真-Embedded ARM7- PLC2124 examples of the development of software using Keil uVision3 through the preparation of the original procedure, software PROTEUS for ARM7- PLC2124 joint virtual simulation

以lpc2119芯片为核心，通过AD端口读取电压值，经双CAN将值传送至CAN-USB转换器后传至上位机-To lpc2119 chip as the core, the port reads the voltage value through the AD, after the value of dual-CAN will be sent to the CAN-USB converter spread after the host computer

Image code download from HOST to memory on S3C4510b board

stm32f407 stm32f4 discoverary 开发板通过 spi2 连接 nokia 5110 3110 lcd，演示了文字显示。

基于STR710 spi接口的MMC/SD卡(SPI模式)驱动程序-STR710 spi interface based on the MMC/SD card (SPI mode) driver

段码液晶 显示资料，资料很全，-Code segment liquid crystal display of information, information is very wide,

三个DS18b20测温点，三选二控制策略，485通信控制，自保持继电器控制，at89c2051控制-3 DS18b20 temperature measurement points, three selected two control strategies, 485 communication control, self-holding relay control, at89c2051 control

一个很好的可以用来调试51单片机的串口程序。-a good 51 can be used to debug the MCU Serial procedures.

使用51单片机STC12C5A60S2，在Keil C下变成，编码盘采集会转速后，单片机根据设定转速与实际转速差值，通过PID算法后得到一个PWM值，给定驱动模块实现数字PID调速。

S3C2440A的windows ce 5.0 bsp包，支持3串口，注册表存储-S3C2440A the windows ce 5.0 bsp package, support 3 serial, registry storage