PIC18 eCAN演示

次程序为单片机89S52系列直流电机驱动程序,具体解释见程序.-meeting procedures SCM 89S52 series DC motor drivers, specific explanation procedures.

3510基于avr的测试程序 建议连接方式： 开发环境：Winavr 版本 ：1.0 MCU ：Mega16 晶振 ：8M 调试环境：AVR Studio-3510 based on the proposed test procedures avr connection: Development Environment: Winavr version: 1.0MCU: Mega16 crystal: 8M debugging environment: AVR Studio

计算机简单控制由软件和硬件组成。软件由Visual Basic 6.0编写。硬件主要由无线发送模块和单片机（C语言编写）构成。通过RS232界面与PC通信而实现无线控制系统。 主要功能是：通过遥控器连接PC机的"上下左右"按键 ,当电脑界面处于powerpoint界面下,能通过遥控器控制幻灯片的上下切换. -Simple control by the computer software and hardware components. Software prepared by the Visual Basic 6.0. Hardware mainly by the wireless sending module and single chip (C language) constitute. Through the RS232 communication interface with the PC wireless control system. Main function is to: Connect PC through a remote control machine up and down about button, when the computer interface in a powerpoint interface via remote control to switch slides up and down.

8位LED显示驱动芯片MAX7219的驱动程序-eight LED display driver chip MAX7219 driver

this program tell you how to connect ps2 to a mcu(for example at89s51)-this program tell you how to connect to a ps2 mcu (for example at89s51)

ADS的中文教程，对于初学者相当的有用，大家多多支持-ADS Chinese Course, quite useful for beginners, everyone can support

利用FPGA的资源实现任意波形的产生，再若和单片机配合就能做成任意的波形发生器。-Use of FPGA resources for the realization of arbitrary waveform generation, again if and SCM can be made with the arbitrary waveform generator.

ps2键盘的命令集，编写键盘驱动时有用。EDH:置位/复位 LED 指示器。键盘右上角有三个 LED 指示器,分别反映 Caps、Num 和 Scroll 三个键的 锁定情况。参数字节如表 2 所列。 -ps2 keyboard command set, the preparation of useful keyboard-driven. EDH: Set/reset LED indicator. The upper right corner of the keyboard has three LED indicators, respectively, reflecting the Caps, Num and Scroll Lock keys in three cases. Parameter bytes as listed in Table 2.

带中断输出功能的时钟芯片例程序,可移值，编译！-With interruption of the clock chip output function Example procedures, can shift the value, the compiler!

我自己写的一个tcp/ip的代码，很短，用的是vc来做模拟调试的，具体的运行是要在mcs51单片机上的，只有一个端口。具体请大家看程序吧！-I wrote it myself a tcp/ip code, in a very short, it was vc do simulation testing, the specific operation is to mcs51 MCU, only one port. Please refer to specific procedures!