The document is based on Samsung 44b0 chip embedded systems arm of the mouth rtl...

ms51 控制sl811读写u盘的源程序 及 原理图 可仿真试一下 -ms51 control u disk read and write sl811 source and schematic simulation to try

这时ARM的调试用程序-time spent debugging procedures

2407pcb版图，对于有一定开发水平的人！此版图很有意义！-2407pcb territory for a certain level of development of the people! This map meaningful!

MW6S004N的升级版，应用比MW6S004N更加广AFT27S006N的幅值为六。是飞思卡尔公司继MW6S004N后的又一款经典

日本北斗电子系统TCP/IP以太网机设计

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

MIPS处理器VHDL代码，实现加法，减法乘除等运算，可综合-MIpscup vith vhdl

深入浅出ARM7书中的源码 周立功 第4章－LPC2131功能部件-ARM7 easy source book weeks Ligong Chapter 4 feature-LPC2131

minigui在arm下的编程环境-MiniGUI arm in the programming environment

lcm显示代码.用于1602的液晶原代码.测试已经通过.-lcm display code