this is only a demo ICCAVR Calling assembly language interrupt function examples...

74HC595在数码管上的详细应用和编程方法-74HC595 in the digital control on the detailed application and programming method

单片机串口通讯源程序，具体功能经过测试，请大家-microcontroller serial communication program, the specific function of the test, please s

modbus的51单片机程序,C语言写成的,测试过了-Modbus 51 Singlechip process, C language, and tested the

这是一个关于PWM调光的程序，二极管等渐灭和渐亮-This is a program on the PWM dimming, diodes, etc., and getting brighter gradually eliminate

这是我大学同学今年的毕业设计项目：基于USB的红外鼠标。红外遥控器模拟鼠标的左右键，还有滚动条。红外接收用HS0038A接收，在这设计中红外处理部分用一块51单片机处理。USB信号处理部分（即USB设备）用51单片机和PDIUSBD12芯片构成-This is my university students graduating this year" s design project: Based on the infrared USB mouse. Infrared remote control analog left and right mouse button, as well as scroll bar. Infrared receiver with HS0038A receive, in the design of mid-infrared processing section 51 with a microcontroller processing. USB signal processing part (ie, USB devices) with 51-chip microcontroller and PDIUSBD12 composition

显示驱动芯片HT1621的C51底层程序-display driver chip HT1621 the bottom procedures C51

Elan eKTP8733N单片机开发程序，用于驱动TIMER接口。在Elan 公司开发环境中使用。-Elan eKTP8733N single-chip development process, used to drive TIMER interface. Elan has developed in the environment.

基于C51的MP3原理图。同学做了很久的。内有电路图。仅供参考。做得很烂。多多包涵。-based on the C51 MP3 schematics. Students do for a long time. Within circuit. For reference purposes only. Do poor-quality. Bear with me.

电机不转，按下启动键，电机旋转，速度为25转/分，按下加1 键，速度增加，按下减1 键，速度降低，最高速度为100 转/分，最低转带为25 转/分，按下停止键，电机停转。速度值要求在数码管上显示出来。-Motor does not turn, press the start button, motor rotation speed of 25 rev/min, press the 1 key, the speed increase by 1 press the button to lower the speed, the maximum speed of 100 r/min, with a minimum of 25 to r/min, press the stop button to stop motor. Speed value of the requirements in the digital tube display.

该文件为研究ps/2协议在鼠标、键盘中的应用。-to study the document ps/2 agreement in the mouse, keyboard of.