是Linux的改写，是实现文件的修改的功能的系统

用CPLD实现NAND FLASH接口的VHDL源码-Using CPLD realize NAND FLASH interface VHDL source code

移植uC/0S-II 到AVR单片机，了解uC/0S-II嵌入式实时操作系统的内核，分析如何将uC/0S-II移植到AVR单片机系统上，并给出一个移植的应用实例。-Transplant uC/OS-II To AVR MCU

飞利浦D12的区动安装及应用程序-Philips D12 District dynamic installation and application procedures

yampp3 mp3 code

SMDK6400原理图,供大家参考学习使用-SMDK6400 schematic for your reference learning to use

嵌入式下对IO口的读写，用C实现的，非常有帮助-Embedded under the IO port to read and write, using the C implementation, very helpful

24c01-24c16读写驱动程序--Driver program for reading/writing 24c01-24c16.

单片机复位电路的可靠性设计复位电路的基本功能是 系统上电时提供复位信号直至系统电源稳定后撤销复位信号为可靠起 见电源稳定后还要经一定的延时才撤销复位信号以防电源开关或电源插头分-合过程中引起的抖动而影 响复位-MCU reset circuit reliability design of the circuit" s basic function is to reset the system power-on reset signal until the system is to provide stable power to withdraw the sake of the reset signal as a reliable power supply stable even after a certain delay to revoke a reset signal to prevent the power switch or Power plug points- combined jitter caused in the course affected by reset

基于PIC16F28的DIY遥控器

经典嵌入式论文，压缩一起上载太慢，所以分开上传！-classic thesis, compressed together on the slow, separate upload!