jtag c 算法经典

双CPU BOOTLOADER 综合实验,不用烧写工具 将.out文件转换成.hex文件烧写到flash里-Integrated dual-CPU BOOTLOADER experiments, no programmer tools. Out files to convert. Hex file to the flash programmer in

这是用于显示波斯语及阿拉伯语及英语中的手臂，源代码与ili9325 液晶。

东南大学开发ARM7芯片SD卡测试程序，完全可用-Southeast University to develop ARM7 chip SD card test procedure, fully available

hyesco AT91RM9200 board boot source code

静态显示8051程序， 将预置在显示缓冲区中的6个数置换成相应的显示字形，然后输出到显示器中显示。运行以上程序，数码管将显示543210。-static display 8,051 procedure will be preset in the display buffer of 6% corresponding number of replacement shows font, then the output to a monitor display. Run the above procedures, digital pipe to show 543,210.

非常容易移植的CF卡驱动程序,在LPC21XX下编译通过,支持UCOS-II.如果想移植到单片机下也非常容易,我就以此版本移植到51的MCU中.-very easy transplant CF card driver, in LPC21XX compiler, support UCOS-II. If you want to migrate to the next SCM also very easy, I would migrate to this version of the MCU 51.

使用硬件SPI接口与74HC595连接，控制74HC595驱动8个LED流水灯显示。-use of hardware and Bit SPI interface connectivity, control Bit-eight LED lights indicate water.

ZLG MINIARM-N20系列最新的底层驱动的使用说明！-ZLG MINIARM-N20 series of up-to-date bottom-driven use!

iic总线协议， 做驱动的可以看看， 很不错的-IIC bus protocol, can be driven to do and see, very good

ARM cortex-M3系列处理器的代码，包括I2C、WatchDog、PWM。（IAR环境工程）-ARM cortex-M3 family of processors code, including I2C, WatchDog, PWM. (IAR Environmental Engineering)