用C语言实现了MSP430单片机tlc5491a A/D数据采集

用485实现单片机之间的串行通信。 主机部分发送从机地址，等待从机响应，从机准备好就发数据,发完就接收从机的响应，接受成功就跳出循环，否则重发。-MCU with 485 Serial Communication between. Host of this address from the plane, waiting for the response from the plane, from the plane ready to discuss the data, finished on the reception of the response from the plane. set aside for recycling success, otherwise re-issued.

这是一个信号发生器的程序，适用于iar环境，可用于msp430的单片机 -This is a signal generator procedures, applicable to iar environment, can be used for MSP430 microcontroller

单片机加无线模块NRF24l01实现其双向通信功能

凌阳单片机的串口通信程序，在SPCE061A芯片上调试通过-Sunplus Single-chip serial communication procedures, in SPCE061A chip debugging through

avr 单片机驱动19264显示屏，带中文 float驱动-avr microcontroller 19264 display driver, with the Chinese float driver

按键扫描驱动程序。51单片机。c语言编程。-button scanning driver. MCU 51. C programming language.

msp430flash型单片机的封装库，呵呵，好东西-msp430flash- Packaging the MCU, what good things

凌阳单片机的机器人能够寻迹，排暴。不同于上一个-Sunplus SCM robot can track finding, Pai storms. Unlike the previous

自己编写的专门针对6122红外编码芯片的红外解码程序,使用定时器+中断,占用CPU时间少,能稳定可靠的解码

NOKIA N1600 显示屏全套开发资料,包括原理图,FPC及LDS184的测试程序,需要了解3线SPI的朋友可以参考.-display full development information, including drawings, LDS184 FPC and the testing procedures need to understand three- SPI friends reference.