VVVF DSP, in the CCS, prepared, used to control the electrical source

这是学习dsp定时器计数器的实验，通过他练习中断的概念，是初学者要做的实验之一-This is a learning experiment dsp timer counter, through the interruption of the notion of practice, he is the one for beginners to do the experiment

按频率抽取计算FFT的C++源代码，可以较方便地移植到有C/C++开发环境的DSP中去-by FFT frequency calculated from the C source code, can be easily ported to the C/C development environment to the DSP

录DEC6713的UART串口的测试程序。需要将板上的跳针JP3、JP5各自短接，将UART通道A 和通道B均配置为RS232方式。-Recorded in the UART serial DEC6713 test procedures. Need to jump on-board pin of JP3, JP5 their shorted to UART channel A and channel B are configured for RS232 mode.

DSP2407的外置AD加DSP的M511伪码产生程序,可下载,烧写,可运行-DSP2407 external AD plus DSP-M511 PN code generation process, can be downloaded, programmer, can run

DSP程序员高手进阶，是学习DSP的好帮手，使你的编程上一个台阶-Master advanced DSP programmers and is a good helper to learn DSP to make your programming to a higher level

老外写的TS201 LinkPort DMA发送/接收程序，学TigerSharc的可以看看。-foreigner wrote TS-201 LinkPort DMA Send/Receive process, TigerSharc the school can look at.

dsp I2C 通信例程，本例介绍了DSP的I2C模块和EEPROM间通信-dsp I2C communication routines, in this case describes the DSP-I2C communication between modules and EEPROM

TMS320VC5509AMMC测试程序-TMS320VC5509AMMC testing procedures

TMS320F2812驱动flash程序-TMS320F2812-driven flash procedure

自己写的TMS320F2812的串口通信程序-Wrote it myself, TMS320F2812 serial communication program