VB编写的上位机程序，接收来自单片机传来的参数

AT91RM9200的USB host和USB device的代码ADS1.2. USB-Device测试程序: 因为程序运行在SDRAM中，所以要先初始化SDRAM（可用basic boot程序初始，之后不能复位或断电），再运行此程序，程序运行后连接USB端口，计算机会提示检测到新硬件，安装硬件驱动程序atmusb6119.inf 后计算机会把USB端口虚拟为一个串行的端口使用-AT91RM9200 the USB host and USB device code ADS1.2.USB-Device test procedure: Because the procedure is running in SDRAM, and so we have to initialize SDRAM (available for the initial basic boot procedure, followed by Can not reset or power off), then Run this program, the program to run after connecting USB port, the computer will be prompted to detect the new hardware, installing hardware drivers after the computer will atmusb6119.inf virtual USB port to a serial port to use

UP-NETARM 2410-S 开发平台 电路原理图-UP-NETARM 2410-S schematic circuit development platform

嵌入式Linux的SD卡驱动程序的设计与实现 题目说的很清楚了！-Embedded Linux driver for the SD Card Design and Implementation of the topic that is very clear!

此代码基于NXP公司的LPC2138ARM7源代码，是2011年全国大学生电子设计大赛智能小车组的源代码，能够驱动小车完成大赛规定的任务并获得了不错的名次！

SVPWM程序,用于三相异步电机变频器的开发和应用-SVPWM procedures for the three-phase asynchronous motor inverter development and application

网络处理器例子程序--Example program for network programming.

full package of jaffs file system

手写识别芯片EPH1100的驱动源码，基于Linux平台.-handwriting recognition chip EPH1100 driver source code, based on the Linux platform.

用汇编写的一个键盘 程序 纯属练习 没价值 用的是矩阵扫瞄法-was compiled using the keyboard a purely procedural exercise did not use the value matrix scanning method

parted-3.0.tar,使用GPT分区，支持超过4T的硬盘分区