用于检测DS18B20 用keil生成hex再用

atmega16单片机与PC机串口通信,编程环境ICCAVR-communicate by single-chip atmega16 and PC through USART

一个320*240的液晶的C51驱动，程序不光可以用在51单片机上，还可以应用在其他单片机上，已成功移植到MSP430，移植时只需要重新改下引脚定义-A 320* 240 LCD drive the C51, the program not only can be used in single-chip microcomputer 51, but also can be applied to other single-chip, this has been successfully transplanted into MSP430, transplantation need to change only the definition of under-pin

ATmega16程序，控制1602液晶，只用了六个I/O口，我仿真过的，没有错误，而且还带Pretues图。-ATmega16 procedures, controls 1602 LCD with only six I/O ports, I" ve simulation, there are no errors, but also with Pretues map.

适用于dos环境的串口通信，很好的程序-dos environment applicable to the serial communication, good procedures!

飞思卡尔中断 Codewarrior for HCS12的中断服务程序编写说明-freescale

51单片机与MAX 7219连接，可一次性驱动8位数码管，绝对正确-MAX 7219 with 51 single-chip connections can be a one-time 8-bit digital tube-driven, absolutely right

采用反正法扫描方法对4X4矩阵式按键进行扫描，判断是哪个按键按下。-Scanning method used in any case law on the 4X4 keypad matrix scan to determine which keys are pressed.

1602加红外 下载过去自己研究一下应该没问题的 程序还是比较简单的-1,602 plus infrared download their past should not look at the procedure is relatively simple

ext实用的俩种布局 好看大方，项目中完全可以拿过来直接用-ext auto Container Control!

掌握单片机的应用开发需要一个过程。首先必须掌握数字电路和模拟电路方面的知识，还必须学习单片机原理、硬件结构、扩展接口和编程语言。-master SCM application development requires a process. One must first master digital circuits and circuit simulation in terms of knowledge, must also learn SCM principle, hardware structure, expansion interfaces and programming languages.