MSP430系列单片机的I2C源程序。可用于对I2C的学习和研究

这是一个汇编语言文件,利用单片机进行温度巡测的设计.-This is a compilation of language paper, using microprocessor Temperature Monitor design.

如文件名，在LPC2138上的I2C的Master发送接受测试程序。里面的readme.txt（英）有详细说明。-If the file name, in the LPC2138 on the Master send I2C tested procedures. Inside the readme.txt (British) has a detailed description.

1.8个流水灯先会从上到下流动一遍，同时蜂鸣器发声。 2.接着DAC电流指示灯由暗变亮 3.接着前三位数码管显示温度值 4.接着AD数值显示在数码管的前三位-1.8 water flows from top to bottom lights will be again, at the same time audible buzzer. 2. And then the current DAC become bright light from the dark 3. And then the top three digital temperature display 4. Then AD numerical display of the top three in the digital control

MSP430F149与ADT7301组成的高精度测温程序，并将温度值转换为ASCII码通过RS232定时上传到计算机。

网线测试仪程序，可测试网线长度（300M内），排序，用脉冲反波测试，时间*速度=距离的原理。-Cable tester program to test cable length (300M) with sorting, using anti-wave test pulse, time* speed = distance principle.

9914芯片寄存器测试源文件,自检芯片使用-9914 chip register testing source, the use of self-test chip

把单片机串口通讯改造为SPI通讯接口源程序，使用C51语言编写，可以用于MCS8051单片机-put microcontroller serial communications to transform SPI interface source, the use of C51 language, which can be used Mcs8051 MCU

keil编译,philip d12。-compiled with keil compiler,and using d12 of philip

Atmel的93C46、8位模式、C51语言。适合MCS-51单片机-Atmel s 93C46, 8-bit mode, C51 language. For MCS-51 single-chip microcomputer

AVR s AVR-CDC ，form OURAVR,COM-AVR s AVR-CDC, form OURAVR, COM