CH375作为usb从设备时的win驱动程序

16f877与MCP2510程序-16f877 procedures and MCP2510

实用遥控器编码程序1-Useful encode program 1 of remote controller

44b0x开发板源代码-44b0x source code development board

嵌入式系统软件开发指南，uClinux到思创S3C44B0黄金开发板的移植。-Embedded System Software Development Guide, uClinux to think Chong S3C44B0 gold development board transplant.

该代码是用自己设计的stm32最小系统，驱动ov7670摄像头，使视频能够显示在3.2寸的液晶屏上

CAN，蜂鸣器，LED灯，EEPROM，IO_KEY，RS232，RS485，RTC，USB，TCP IP

应用背景 VB写的控制程序，通过PC端上位机控制，在电路板上实现相应的演示效果。  VB write control procedures, through the PC side of the upper computer control, on the circuit board to achieve the corresponding demonstration effect. 关键技术首先 烧写程序到单片机   晶振 11.0592MHZ连接好串口线打开上位机软件 选择好COM端口  设置波特率为9600 First of all burn to write programs to chip crystal 11.0592Mhz serial line connection open PC software select the COM port to set the baud rate of 9600

此书是关于cu/os的书，可以帮助嵌入式开发的朋友们。-This book is about the cu/os a book that can help embedded development friends.

基于LPC2378的CAN通信程序，实现两个CAN的自发自收-LPC2378

搞嵌入式系统设计的必看-engage in the embedded system design Watchable