ATMEL AT91SAM USB Mass Storage Module

程序包含了一个USB和UART相互转换的模块代码,其中包含了PCB电路图,和PC驱动程序.-procedure includes a USB and UART conversion module code, This included PCB circuit, and PC drivers.

嵌入式基于ARM的仿真软件skyeye的介绍和安装方法，及仿真linux的步骤。-ARM-based embedded software simulation skyeye the introduction and installation methods, and simulation steps linux.

YAFFS的升级版本YAFFS2，很好的支持NANDFlash的文件系统-YAFFS updates YAFFS2 good support NANDFlash file system

超小usb协议栈，完整实现！值得一看哦~-Ultra-small usb protocol stack, complete realize! Well worth a visit ~

基于AT91RM9200的Linux二进制代码文件，一共670k，能够在目标板上运行。大家多多上传阿-based AT91RM9200 Linux binary code files, a total of 670K to run in the target board. Members can upload A

一个用于PC直接写端口及内存的程序，少加修改就可用于pci卡的驱动，完整的工程代码，非常不错-a written directly for the PC port and the memory process, less modification can be used to drive pci cards, and complete code works very well

ARM-LINUX,基于S3c2410处理器的开发板实验源代码-ARM-LINUX, based S3C2410 processor development board test source code

A Simple isochronous transfer. Reads 8051 ports A,B and C, and continuously sends a five byte packet over EP8IN:

5位LED显示驱动芯片14498的显示驱动-five LED display driver chip 14498 display driver

通过键盘设定温度和加热时间。 （2）使用DS18B20采集温度，采用七段数码管显示当前温度和剩余时间，并和设置的温度进行比较。 （3）当温度低于设定值时，通过DAC0832输出电压供给发热电阻RT1,使其温度升高。 -Through the keyboard setting temperature and heating time. (2) The use of DS18B20 collecting temperature, using seven-segment digital tube displays the current temperature and the remaining time, and and set the temperature for comparison. (3) When the temperature is below the set value, the DAC0832 output voltage of the supply of heat through the resistor RT1, so that temperature.