all elected

51单片机教程,简单易懂,是很容易学的教程!最适合初学者的入门啦!-51 SCM Guide, easily understood, is very easy to learn from the other! The most suitable for beginners entry!

使用C8051F410进行的AD转换程序，并带有与计算机的串口通信-C8051F410 carried out using the AD conversion process, and with the computer" s serial communication with the

用C51编写的电热水壶C51程序，附详细的代码，测试通过，放心使用，请认真参考-C51 with C51, prepared by Electric Kettle procedures, with detailed code, test, ease of use, please give serious consideration to

单片机操作EEPROM 240X的程序。 非原创，转载。-EEPROM 240X MCU operating procedures. Non-original and reproduced.

320240lcd Drive 89系列单片机通用-320240lcd Drive 89 Series Single-chip Universal

比较完成的FAT文件系统与单片实验,本系统利用AVR-Comparison of completed FAT file system and single-chip experiment, the system uses AVR

8x8矩阵示例

51单片机对IC卡读写程序，使用的卡的型号为SLE4442,有帮助就下。-51 microcontroller IC Card Reader right, the use of the card for the Model SLE4442, help on the next.

keilc + proteus 并行口设计指示灯实验 要求：掌握80C51单片机输入输出接口使用方法 学会开关量输入输出控制的接口技术及编程方法 实验题目：8个发光二极管D1~D8分别接在单片机P1.0-P1.7端口上，一个开关接在P3.0上。要求输出端口输出 “0”时，发光二极管亮。开关闭合时，开始按P1.0-P1.1-...-P1.7的顺序依次点亮LED，再按 P1.7-P1.6 -...-P1.0的顺序点亮LED，重复循环。开关断开时，立刻停止点亮指示灯。-keilc+ proteus light parallel port design of experiments requirements: master the 80C51 microcontroller input and output interfaces Society of switch to use the amount of input and output control interface technology and programming methods Experimental subjects: eight light-emitting diodes D1 ~ D8, respectively connected to the MCU P1.0-P1 .7 port on a switch connected to the P3.0 on. Requested output port output " 0" , the light-emitting diode light. Is closed, to embark on the P1.0-P1.1-...- P1.7 in the order light LED, and then P1.7-P1.6-...- P1.0 order light LED Repeat cycle. Switch off when the stop light indicator.

测试can总线好坏的vc源码-test can vc bus close to the source