ucos在三星s3c44b0上的键盘程序

基于STM2的uCOS程序编写，信号量通信及DMA传输。(STM2 of uCOS based programming, semaphore communication.)

ucOs-ii完整源代码，极其方便用户调用-ucOs-ii complete source code, an extremely user-friendly call

1.板上的8 个按键分别分别代表数字1-8，按下一个按键将结果通过串口发送到PC机上显示； 2.使用两个定时器模块，分别定时为1ms 和100ms 产生中断，使用它们分别 产生1s的定时时间，将时间分别显示到数码管上； 3.外接PS/2小键盘，将按键的值通过串口显示到PC机上。(A panel of eight key representing the number 1-8 press a key the results sent through the serial port on a PC display (2) use two timer modules, respectively, of 1ms and 100ms timer generates an interrupt, use them, respectively, Produce the timing of the 1s, the time display to the digital control External PS/2 keyboard, the key value of displayed through the serial port to a PC.)

在KEIL下使用UCOS来编写程式，还不错(in UCOS KEIL use to write programs, but also good)

second.rar 这个做的是一秒表计时程序，是用FPGA写的，里面代码完整，并带有文档报告-second.rar this is the one to do stopwatch timing procedures, FPGA is written inside the code integrity, and with the report document

ucosII在S3C2410上移植的启动代码,对开始开发S3C2410的人有一定的帮助-ucosII S3C2410 transplant boot code, to begin developing the S3C2410 will help

uc/os基于TI tms320dsp28312的移植-the transplant of the rtos-ucos for TI tms320dsp28312

ADS环境下在S3C44B0X芯片上实现uCOSII操作系统的系统的消息循环。-S3C44B0X chip under the ADS environment to achieve uCOSII operating system message loop.

这是本人调用small rtos51的函数来仿真写的基本代码-This is a small rtos51 I call a function to write the basic code simulation

说明：  介绍uCOS-II操作系统的安装； 深入剖析uCOS-II操作系统内核运行机制； 在各种平台上移植uCOS-II。(Introduction uCOS-II operating system installation in-depth analysis uCOS-II operating system kernel operating mechanism in a variety of platforms transplantation uCOS-II.)