智能车测速程序 智能车测速程序

本程序是msp430单片机的UART模块的典型示例，对于初学者很有用-This program is msp430 microcontroller UART module typical example, is useful for beginners

凌阳61板锯齿波发生程序，可以在产生示波器上产生锯齿波-Sunplus 61 sawtooth board programmed, you can have a sawtooth generated Oscilloscopes

CAN控制器2515的J1939库源程序-CAN Controller 2515 for the source J1939

压缩文件包括电磁炉的控制程序和其原理电路图！方便大家阅读程序，配合原理图阅读！-compressed files including Induction Cooker control procedures and its tenets circuit! To facilitate reading the procedure to incorporate the diagram read!

51 编程模板，单片机代码集合 裁减后可以方便编程-51 programming template, microcontroller code can be set after the reduction of programming convenience

智能计数器，对外部信号脉冲进行计数，并将脉冲个数显示出来。 基本要求：计数至少65536个脉冲，并将脉冲个数显示出来。 -intelligent counter, the external signal pulse counting, pulse number will be displayed. Basic requirements : at least 65,536 Count pulse, and pulse number displayed.

这是我同学在上海交大实习的时候做的一个单片机的verilog代码实现，希望对大家有帮助-This is my internship students of National Chiao Tung University in Shanghai to do when a single chip verilog code, and they hope to help you

用89S52编的的蜂鸣器发声，有点简单，但最为一个发声的实力来说足够了-89S52 series with the buzzer sound, a bit simple, but most of the strength of a voice enough for the

12864LCD显示控制 可以显示图形和动画-12864LCD display control can display graphics and animation