c51读写24cxx程序模块，已调试过，ok 工具Keil uVision2

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

12864中文资料，写有基本的使用指令-12864 Chinese data, writing the use of basic commands

程序描述：使用Cypress的Cy7C68013A芯片进行设计，控制外部LED数码管的显示。程序包括USB固件程序以及主机程序。 安装：把源码拷贝到硬盘特定目录下，使用Keil C编译器和Visual C++ 6.0运行即可。 注意：可以首先使用Cypress的调试工具进行固件程序的调试，以确保固件程序的正确性。 -Description: Using Cypress

触摸屏基础知识大全与最新多点触摸屏技术介绍-多点位置识别-Basic knowledge of touch screen Guinness with the latest multi-point touch screen technology introduction- multi-point location identification

AVR单片机的源代码，VHDL代码。实现了AVR单片机的功能。-AVR microcontroller source code, VHDL code. AVR microcontroller implements the function.

C51系列接触式IC卡读写实验程序，用汇编语言实现-C51 series of contactless IC card reading and writing test procedures, using assembly language to achieve

嵌入式控制器硬件电路设计。里面有介绍各种嵌入式控制器，及其电路设计和软件实现-Embedded controller hardware design. Which have introduced a variety of embedded controllers, and circuit design and software implementation

华大机顶盒源码(包括所有源代码).rar-Mandarin source set-top boxes (including all source code). Rar

SPC3 PROGRAMS SP C3 PROGRAMS

最简单的TCP协议栈，只包括ICMP,ARP,TCP/IP等实用功能