LT_1B msp430开发板例子程序－TA_

2262和2272的发射接收源码，很简单-2262 and 2272 of the transmitting and receiving source code is very simple

用pic18f8720做的电压采样处理程序，带了proteus仿真图的！-Pic18f8720 to do with the voltage sampling process, with the Proteus simulation chart!

该程序基于凌阳单片机做的无线温度遥测系统，并在液晶屏上进行显示-Sunplus based on the program to do single-chip wireless telemetry system temperature, and liquid crystal display screen. . .

SPI接口型E2PROM内部存储器的组织及读.写控制方法.-SPI Interface-type E2PROM internal memory of the organization and read. Write control methods.

学习51的要关注哦,是STC的烧录软件,方便51单片机学习,通过串口就可一烧写程序,减少开发费用,-learning the concern Oh, STC is the replication software for 51 MCU study, through a serial port can be burning, reduce development costs,

STC89C52单片机 主频：11.0592M 模块名称：SED1520驱动12232液晶驱动-STC89C52 Singlechip frequency: 11.0592M Module name: SED1520 LCD driver 12232 driver

本程序已经调试通过，使用I2C来从外部时钟芯片中读取并写入时间。文档包含i2c的驱动程序、时钟芯片的读与写、以及使用定时器中断产生脉冲来模拟gps对时。-This procedure has been debugging through the use of I2C chip from the external clock time to read and write. Document contains the i2c driver, the clock read and write chip, and the use of the timer interrupt to simulate the pulse generated when the gps on.

/* 程序详细功能介绍： *当按下按键P3.3 ，AT89S51单片机产生“叮咚”声从P3.2端口输出 *程序设计方法 * 1． 我们用单片机实定时/计数器T0来产生700HZ和500HZ的频率，根据定时/计数器T0，我们取定时250us， * 因此，700HZ的频率要经过3次250us的定时，而500HZ的频率要经过4次250us的定时。 * 2． 在设计过程，只有当按下SP1之后，才启动T0开始工作，当T0工作完毕，回到最初状态。 * 3． “叮”和“咚”声音各占用0.5秒，因此定时/计数器T0要完成0.5秒的定时，对于以250us为基准定时2000次才可以。 */-/* Procedure detailed functional Introduction:* When pressing the button P3.3, AT89S51 Singlechip a

vhjhkjhjkj,mnbjk

8*8点阵LED显示器的设计 并且有原程序和说明 很好的-8* 8 dot matrix LED displays and the design of the original procedure and a good note