8051

LCD程序hmn 民间 搞活 才 各个-LCD HMN civil enliven the proceedings before a

本设计的由单片机控制的自动加料系统是与料斗式干燥机配套的加料系统。根据加料工艺要求，其工作原理是：先将真空管关闭，启动电机，用低真空气流将塑料树脂粒子送入真空管，电机停转，再将粒子排入料斗，如此循环。-The design of single-chip microcomputer controlled by the automatic feeding system with hopper dryer feed supporting system. Charging process in accordance with the requirements of its working principle is: first vacuum tube to close, start motor, using low vacuum plastic resin particles will flow into the vacuum tube, the electrical switch to stop, and then particles into the hopper, and so the cycle.

msp430f169 中断方式驱动4*4矩阵键盘-msp430f169 interrupt-driven 4* 4 matrix keyboard

51系列单片机的uCOS-II原代码-51 Series MCU uCOS-II source code

arm2410各种基础实验,已通过测试,内容: LCD控制器.doc 看门狗定时器.doc 定时器.doc 中断控制器.doc DMA 控制器.doc ad.doc 7279键盘和数码管.doc IIC 总线接口.doc IIC 总线接口.doc RTC.doc UART.doc-arm2410 various experimental basis, has been tested to be content: LCD controller. doc watchdog timer. doc timer. doc interrupt controller. docDMA controller. docad.doc7279 keyboard and digital tube. docIIC bus interface. docIIC bus interface. docRTC.docUART.doc

基于18b20和单片机控制的温度采集及显示系统-18b20-based single-chip microcomputer to control the temperature and the acquisition and display system

智能计数器，对外部信号脉冲进行计数，并将脉冲个数显示出来。 基本要求：计数至少65536个脉冲，并将脉冲个数显示出来。 -intelligent counter, the external signal pulse counting, pulse number will be displayed. Basic requirements : at least 65,536 Count pulse, and pulse number displayed.

CC1000 RF芯片的初始化及发送程序，C语言-CC1000 RF chip initialization and sending process, C language

原创24C256读写程序，绝对好用-original 24C256 literacy procedures, absolutely handy

这是关于根据按键显示灯亮的源代码，主芯片是51单片机-This is a button on the display lights in accordance with the source code, the main chip is a single-chip 51