ucosII in the AT91RM9200

一段基于ucos系统的程序，运行在S3C2440上，方便测试(A UCOS system based on the program, run in S3C2440, easily test)

工作中正在用的, uCOS 的移植,本来有8个文件，我合并成4个-work is being used, for uCOS transplant had an eight papers, I merged into four, and

基于 Philips 公司的 ARM-7 使用之 uC/OS-II 作业系统,此例程是移植于 LPC-2888 上的应用,不同于一般的 Porting 其最主要是加入了支援 OS_View 观察器功能,于 IAR EWARM V4.41A 工程编译,而 uC/OS 版本为 2.83-Based on the Philips company

该代码采用KEIL平台开发DS18B20，MCU选择LPC2132-The code using KEIL platform development DS18B20, MCU selection LPC2132

可直接用于Atmel AT91SAM7X256_EK板的简单Web服务器程序， AT91SAM7X256（MAC)+DM9161AE（PHY），Web程序中设定的IP地址192.168.131.200,MAC地址 00-30-6C－00-00-02详见emac_lib.h与ethernetif.c,可在IE浏览器中输入查看，注：MDIX跳线未短接时，PC与EK板均需要通过UTP网线接至交换机，MDIX短接时可用网线直连PC。-Can be used directly Atmel AT91SAM7X256_EK board a simple Web server program, AT91SAM7X256 (MAC)+ DM9161AE (PHY), Web procedure set IP address of 192.168.131.200, MAC address 00-30-6C-00-00-02 see emac_lib.h and ethernetif.c, in IE browser, enter the view, note: MDIX when the jumper is not shorted, PC and EK boards come through UTP cable connected to the switch, MDIX cable shorted available when Direct Connect PC.

移植到MCS51的uCOS_II的串口程序。-transplanted to the MCS51 uCOS_II Serial procedures.

ucos移植到lpc2131的arm模板(OUT transplanted to the arm template lpc2131)

The best new for ucos ebook

UCOS/2对MSP430的嵌入式代码-UCOS/2 on the MSP430 embedded code

在LPC2210平台，CAN通信协议在UC_OS操作系统中的实现代码；开发环境为ADS1.2-In the LPC2210 platform, CAN communication protocol in UC_OS the realization of the operating system code development environment for ADS1.2