飞利浦51LPC系列单片机对交流电机控制的电路原理图和源程序

DS1302HT1302实时时钟与89C2051接口子程序

本文件为单片机的延时子程序，采用8051f040系列单片机，供单片机初学者学习使用。-This document is for single-chip delay of the subroutine, the use of single-chip 8051f040 series for beginners to learn the use of single-chip microcomputer.

I2c如 IIc 24LC64等器件的51单片机驱动程序,已经通过实际验证,很好用的-I2c such as IIc 24LC64 51 microcontroller device driver, has been through actual test Oh good use

我自己编的一个一位数码管减计数的学习程序，在pic16f73已经验证了。-myself a part of a digital control by counting the learning process, as demonstrated in the pic16f73.

一个单片机对EEPROM AT24C02的读写程序。绝对好用。-A single-chip EEPROM AT24C02 on reading and writing process. Absolute ease of use.

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4, 每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

触摸屏的校正程序。可以用于触摸屏的校正。在三星的平台上测试通过-Touch screen calibration procedure. Can be used for touch-screen calibration. Samsung

AT8091 C51 4*4键盘 程序例子，配电路图-AT8091 C51 4*4 Keyboard example

胎压检测系统接收部分源码-tire pressure detection system to receive some source

CC2430 基础实验十 片内温度的实验-CC2430 10 experiments based on the experimental temperature