A drive source lcd9320 interested readers can

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

tms320c2812的can总线驱动，源码直接可以编译使用！-tms320c2812 the can bus driver, source code can be compiled directly using!

MATLAB程序，用于dsp编程软件仿真，信号的产生，fft变换-MATLABghdsp

ARMBOOT源码1.0.1 ＡＲＭ嵌入式开发启动通用代码．-ARMBOOT source 1.0.1 ARM Embedded Development launched generic code.

arm做的MP3播放器,自己公司开发的MP3播放器的源码.-arm to do the MP3 player, the company developed its own MP3 player source.

代步两轮自平衡车，采用ADX330+IDG+ARM控制，卡尔曼滤波，PID控制，实现自平衡和平地动行转弯，供大家学习参考

初始化串口； 串口单字节发; 串口多字节发； 串口中断接收

周立功公司的arm学习板附送的MODEM驱动例程-weeks arm of the company, who study plate attached MODEM Driver routines

easyArm2100工程模版，周立功仿真套件-easyArm2100 project templates, Zhou, who Simulation Boards

S3C2440处理器上的RTC程序，已经经过验证。-S3C2440 processor RTC procedures, has been verified.