硬盘控制电路以及原程序Demo,知识是属于全人类的。能将自己的成果无条件与人共享是伟大和受人尊敬的，同时也是一件幸福的事。 由于我想得到幸福和受人尊敬，所以...

单片机与FPGA控制128*64液晶显示程序，用总线方式控制

IC卡操作Demo 包括了常见的IC卡种类。可执行写入、读出、校验、密码修改、批量作业等功能。-IC crepe Fuzeng brazing Demo women are rude mamma residual cavity IC Crepe undress 。 Se Joon Gou写shallow embankment millet 入))) corchorifolius Guang hesitate码party clam) silkworm brazing stresses bulging features quickly-deteriorating jade 。

利用中文字型点矩阵控制器ST7290编写的清屏,移动光标等函数-The use of Chinese fonts dot matrix controller ST7290 clearance preparation screen, move the cursor and other functions

日历时钟显示汇编程序,注释很详细,保证能很快看懂-Dang显钟时日Sa striped met the most序, agate细Note释exhaust, exhaust Xikui despair殿vessels do ya

PIC单片机驱动TCS230 TCS230可以辨别颜色,广泛用于各种领域-PIC microcontroller-driven TCS230

有单片机控制的12864图形显示程序，，有汉字和图形的程序-There are 12,864 single-chip graphic display control procedures, there are Chinese characters and graphics procedures

单片机汇编代码，有大部的多字节运算，通信和字符变换程序-MCU code compilation, the most multi-byte computing, communications and characters transform procedures

用ATMega单片机做的跑马灯的程序代码-MCU to do with the ATMega Marquee program code

P1.7～P1.0接发光二极管L8～L1，要求利用单片机内部定时器1，按方式1工作，每0.01秒T1溢出中断一次。要求编写程序模拟时序控制装置。开机第1秒钟L1、L3亮，第2秒钟L2、L4亮，第3秒钟L5、L7亮，第4秒钟L6、L8亮，第5秒钟L1、L3、L5、L7亮，第6秒钟L2、L4、L6、L8亮，第7秒钟8个发光二极管全亮，……一直循环下去。fosc=11.0592MHz-P1.7- P1.0 then LED L1 to L8, by using a timer internal microcontroller, a work by the way, every 0.01 seconds T1 interrupted an overflow. Simulation prepared timing control device. Boot 1 seconds L1, L3- liang, two seconds L2- L4, L5 three seconds, L7- liang, 4 seconds L6, L8-liang, 5 seconds L1, L2, L5, L7- liang, 6 seconds L2, L4, L6, L8- , 7 seconds 8-LED whole ... has been the cycle continues. 11.0592MHz fosc =

CC2430 基础实验十一 1/3AVDD的实验-CC2430 11 experiments 1/3AVDD the basis of the experimental