CCS的运 行环境下的DSP2812种部分程序代码，刚刚学习，希望大家有所帮助...

DSP开发必备文件-DSP Development Necessary Documents

这是一个关于DSP定点和浮点运算的比较详细的解释,多学习DSP帮助很大-This is a study on fixed-point DSP and floating-point operations in a more detailed explanation, very helpful learning DSP

tms320f2812aFFT程序 调试好的 供交流-tms320f2812aFFT procedures for the exchange of good debugging

DSP2812下,C调汇编的128点FFT程序,算法为TI提供,定点,测量信号频率和幅度较好,速度比C快三倍左右.-DSP2812 under, C tune compiled 128 points FFT procedures, algorithms for TI to provide, point, measure the signal frequency and amplitude is better, faster than C for about three times faster.

dspbios的说明及使用方法，对初学者非常有好处！-dspbios the note and methods of use, very good for beginners!

合众达开发板的基于dsp通用输入输出口（GPIO）源程序调试。-United Development Board of dsp-based general-purpose input output (GPIO) source code debugging.

DSP2812的跑马灯程序，适合2812初学者用C开发用，已调制通过，开发环境为CCS-DSP2812

TI CMD用于FLASH的可以使用的文件-TI CMD can be used for the FLASH of the document

通过save data的方式可以将数据从DSP板的内存中将数据读出存储到一个文件中，此时该文件中的内容是对内存中的数据添加了一定格式的，格式见“yuv图像文件到CCS中DAT文件的转换 ”，下面的程序完成取出ccs添加的格式，留下纯数据，并将之存储到一个新的文件中-The way through the save data can be data from the DSP board memory will be read out data stored in a file, the contents of the file at this time is to add data in memory a certain format, the format, see " yuv image files to the CCS in the DAT file conversion " , the following procedures are completed to add the format ccs removed, leaving the pure data, and the store to a new file

本文件提供了SWWP的DSP2812解决方案源程序，希望对电机驱动设计及其它设计者有所帮助-This document provides solutions SWWP source of the DSP2812, in the hope that the design of motor drives and other designers to help