msp430ex44x试验程序代码包括 io口，spi通信，定时器，实时时钟等代码，非常全...

HZ12864串口显示液晶的51单片机驱动程序（KEIL工程文件）-HZ12864 serial liquid crystal display driver 51 MCU (KEIL project file)

用ASM语言编写的二十进制转换代码.有价值-ASM language with the two Decimal code. Value

1602字符液晶驱动实例源代码，在keil c上调试通过并实际验证-1602 characters LCD driver source code examples in keil c debug adopted and the actual verification

pic16f上12864液晶显示，ad转换程序，时钟显示程序，串口程序。-12864 LCD pic16f on, ad conversion process, the clock display program, serial program.

嵌入式/单片机编程 嵌入式/单片机编程1 嵌入式/单片机编程2 -Embedded/Microcontroller Programmer Embedded/Embedded Microcontroller Programmer 1/2 Microcontroller Programmer

Keil　C的调试经验-Keil C debugging experience

Keil C51，带有EEPROM的读写和按键、菜单及数码管显示与一体的单片机程序，已通过调试-Keil C51, with the read and write EEPROM and buttons, menus and digital display with integrated single-chip process, has passed through debugging

spi 翻译资料 7.2 SPI总线 SD卡信道由指令和数据位（起始位和结束位）组成，SPI信道由字节定向。 每一个指令或数据块由8位的字节和CS标志构成。类似SD卡协议, SPI通讯由 指令、响应和数据组成。全部的主机与SD卡之间的通信由主机控制。主机执行 每一跟CS标志为低的总线-spi Translation 7.2 SPI bus data channel from the SD card command and data bit (start bit and end bit) component, SPI channel directed by byte. Every command or data block from 8-bit bytes and CS constitute signs. SD card similar to the agreement, SPI communications from command, response and data components. All of the host and the communications between the SD card by the host control. Each host implementation with CS low marks for bus

DAC1230是一个12位的模数转换的芯片!而使用时候是在8位的单片机上运行,所以需要注意高四位和低八位的写入时序-DAC1230 is a 12-bit analog-digital conversion chips! Use of time in the 8-bit single-chip run, so it is necessary to pay attention to the high four and low eight write timing