通用建业主

ARM处理器软中断处理。a_swi.s文件是最开始处理的SWI句柄,用ARM汇编指令编写。c_swi.c文件是在执行a_swi.s文件之后调用执行的C语言SWI句柄。 -ARM processor soft interrupt handling. a_swi.s document is the beginning of the SWI handler deal with the preparation of ARM compilation directives. c_swi.c document is in the implementation of a_swi.s document called the C language implementation of SWI handler.

应用背景 TI的F28335芯片的Controlsuit例程包，基于CCStudio v5的开发 关键技术F28335的例程，包括SCI，spi，MCbsp等外设的例程，可做相关的demo板的测试。

本文是我学习ARM开发以来的一些经验总结，以自己设计的S3C44B0X板为例，给出我调试开发ARM开发板的一些最基础知识。我只是在自己的开发板调试过并且经验有限，有些知识只能做为参考，不一定准确，就算给大家一个“例程”吧，如果大家有不同意见，希望多多指正！-ARM since learning some lessons learned, in their own design S3C44B0X an example, I presented the development and debugging of the ARM development board some of the most basic knowledge. I was only in their own development boards tuned and limited experience, some knowledge only as a reference, not necessarily accurate, even if everyone with a "routine" for the country, if we have different opinions, many correct!

STM32新建工程模板，新学者可以参考修改，希望对初学者有帮助

描述了如何配置stm32f10x的ADC控制寄存器，ADC1被配置为有顺序地转换第14与17通道的模拟输入量，ADC2被配置为有顺序地转换第10与11通道的模拟输入量。-This example describes how to use ADC1 and ADC2 in regular simultaneous dual mode. ADC1 is configured to convert channel14 and channel17 regular channel continuously. ADC2 is configured to convert channel10 and channel11 regular channel continuously.

s3c44b0x系列arm7开发板串口测试程序。ADX调试即可-s3c44b0x series arm7 Development Board serial testing procedures. Debugging can ADX

USB通信源代码，适合LPC214X的USB开发。-USB communications source code for the USB development LPC214X.

一些ARM入门的原代码， 和大家分享下。-Introduction to some of the original ARM code, and under the U.S. share.

linux下的jtag仿真器程序，可使用在arm7（44b0，4510，2410等）和arm9上面，可以烧写flash 39lv160等，再不用两个系统不停重启了。-the JTAG Emulator procedures, the use of the ARM7 (44b0, 4510,2410) and arm9 above, 39lv160 burning flash, no longer have to keep two systems resumed.

一个基于ARM平台的触摸屏程序。-an ARM-based platform Touchscreen procedures.