本人设计的12864完美小屏程序，供大家参考・

电子定时器的设计 有程序的具体实现和功能描述 好的程序-electronic timer with the design of specific procedures to achieve good functional description and procedures

基于CAN总线的电梯控制系统，包括主板程序，子板程序和电路原理图-Based on CAN Bus elevator control system, including the board procedures, sub-board procedures and circuit diagram

网上找到的PCF8563程序基本不能用 本程序基于51单片机，模拟了I2C接口，现已调试成功，可以做成万年历了

silcom实验室c8051f340 pwm

用C写的I2C总线EEPROM读写程序，在MSP430＋AT24C64～512平台上验证通过。对其他处理器只需简单修改即可使用。-C write I2C EEPROM read and write procedures, the AT24C64 MSP430+ ~ 512 platform validation through. The only other processor can use a simple amendment.

自己写的lcd1602的驱动程序，底层驱动和上层程序层次分明，很容易移植-?????#39 的lcd1602的驱 ???绦??????闱????蜕????绦???39 ?置 ????苋菀 ?移?

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

51单片机驱动128X64液晶的程序。里面包括显示16X16点阵字符、显示8X16点阵字符、显示光标、clr光标等子程序。用C51编写-51 microcontroller drives the built LCD procedures. They show audio Character, character dot-matrix display 8X16 show that the cursor, such as the cursor clr subroutine. Prepared with C51

ili9325TFT彩屏驱动器初始化源码-color ili9325TFT drive initialization source

开发环境为keil166，使用xc164cs从can接收数据 在串口定时发送-Development environment for keil166, the use of xc164cs from the serial port can receive data sent from time to time