基于ARM芯片S3C2410的TFT

ARM开发详解CRC算法原理及C语言实现-CRC algorithms for C Language

与合作 UART STM32F103 通过 CMSIS 图书馆。初始化、 原始写入和读取从端口。

altera nois cpu.Very good.

S3C2440处理器上的RTC程序，已经经过验证。-S3C2440 processor RTC procedures, has been verified.

这个例子如果运行,将在仿真的PC窗口中的第1,2,3行显示一些信息后,在随机位置显示 1 ~ 5 .由于keil c51默认不支持重入函数,它的重入函数使用仿真的重入栈而不使用系统栈,而Small RTOS 51没有进行重入栈管理,所以在TaskA~TaskE虽然及其相似,但不能合并. (2)编译时会有5个警告,其中一个是因为没有使用一个系统函数OSSendSignal引起,它可以忽略.另4个是禁止任务间变量覆盖分析引起,必须忽略.感谢网友John X. Liu,在这个例子中我使用了他编写的仿真(dllPc51Emu.dll),这个dll原来是为他移植的Ucos-ii for keil c51的例子编写.-If you are running this example, will the PC emulation window, the first 1,2,3-line display some information, at random locations show " 1 " ~ " 5" . Keil c51 as the default does not support the re-entry function, which re- into the function of the weight stack instead of using the simulation using the system stack, while the Small RTOS 51 not been re-stack management, and so TaskA ~ TaskE though its similar, but not combined. (2) compile-time there will be five warnings, One of them is because there is no cause to use a system function OSSendSignal, it can be ignored. The other four are prohibited between the variables covered analyze the task to be ignored. thank User

这是16位定点dsp源代码。已仿真和综合过了-This is a 16-bit fixed-point dsp source code. Simulation and synthesis has been

arm网络驱动程序-arm Network Driver

STM32 开发板例子:IWDG 内部看门狗. 开发环境:Keil For ARM-STM32 development board example: IWDG internal watchdog. Development Environment: Keil For ARM

基于ARM Cortex-M3内核的STM32F103RBT6处理器为核心构建柔性锁相环的硬件实验平台，在STM32中模拟出三相电源电压，并在子程序中实现了SRF-PLL、DDSRF-PLL与DSOGI-PLL三种锁相环，通过IO口并行输出锁相结果，再通过DAC转换为可观测的模拟信号。源码包中包含了软件工程与硬件电路原理图两部分。

用arm驱动hp 1020打印机所需要的驱动-With the arm driver hp 1020 printer driver needed