逆变器仿真程序，可以进行直流/直流工程仿真

三点式振荡器是指LC回路的三个端点与晶体管的三个电极分别连接而成的电路，如图4-1（a）所示。图中三个电抗元件X1、X2、X3构成了决定振荡频率的并联谐振回路，同时也构成了正反馈所需的反馈网络。从相位条件看，要构成振荡器，必须满足： (1)极相连的两个电抗X1、X2性质相同。 (2)X1与X2、X3的电抗性质相反。-three-point refers to LC oscillator circuit with three transistors endpoint of three electrodes were connected with the circuit, Figure 4-1 (a) below. Figure 3 reactor components X1, X2, X3 decision constitutes a frequency of the oscillation parallel resonant circuit, but also constitutes a positive feedback for the feedback network. From Phase conditions, to constitute an oscillator, to be met : (a) very connected to the two reactor X1, X2 the same nature. (2) X1 and X2, X3 nature of the resistance-- contrary.

QPSK的MATLAB仿真,仅供大家学习-QPSK the MATLAB simulation, for everyone to learn

turbo码搭建了简单的系统来进行纠错展示,可以实现从编码,加入错误,译码,输入输出码字对比等基本功能,另外加入了交互模块,用户可以自己设定错误比特的数目和位置,使纠错功能显而易见.-turbo codes built a simple system for correcting display, from coding can be achieved by adding errors, Decoding, input and output code contrast basic functions, adding to its interactive modules, Users can set their own errors and the number of bits, so that error-correcting functions obvious.

ISUP协议规范，对于学习ISUP协议，阅读规范是一个不错的方法。尤其对于深入的理解协议，阅读规范是一个不错的手段。-ISUP protocol specification ISUP protocol for studying, reading norms are a good way. Especially in-depth understanding of the agreement, read the specification is a good means.

电话拨号演示系统（需硬件板卡支持）-telephone dial-up demonstration systems (hardware board support required)

一个交换作业的源程序-a source of exchange operations

安防系统，应用电影螳螂蛋窝的奶油标准谭市下一届大师协会定

DS-CDMA一种具体的码分导引辅助的信道估计方法-DS-CDMA

高斯脉冲的微分。先将高斯脉冲及其前15阶导函数的幅度归一化，然后将它们同时画出。-Differential Gaussian pulse. Gaussian pulse and its first order derivative function of the first 15 normalized magnitude, and then draw them at the same time.

个人认为比较使用的几个VHDL源码之四multiplexer的源码-personally think that the use of the relatively few VHDL source 4 multiplexer the source