arm

Motor application for board H8S 2377R

rtx-tiny源码-rtx-tiny FOSS

使用DSP2812开发板进行AD转换的实例。该实例通过EVA启动AD转换，结果储存在AdcRegs.RESULTX寄存器中，结果为Q30格式。切记输入电压需调理至0-3 V之间，否则会烧坏DSP。

基于ＡＴＭＥＧＡ１６的步进电机的驱动程序，-Based on ATmega16 of stepper motor drivers,

一个信号发生器的程序。--A signal generator.

压力测量,采集压力值程序-pressure measurement, pressure on the value of acquisition procedures

在89C51芯片上运行，采用两个中断方式，一个外部0中断实现救护车通行，南北红灯10秒后恢复中断前状态，另一个是定时器0中断实现南北灯状态转换，16X16 LED点阵对应显示“南北”字样信息-89C51 chip in operation, interruption of the use of two methods to achieve an external 0 interrupt the passage of ambulances, the North-South red light 10 seconds after the resumption of state, and the other is the timer 0 interrupt to achieve the state of North-South light conversion, 16X16 LED dot-matrix corresponding show " South-North" in the information

Moto E2的键盘软锁v2源代码，使用qt，（0.02版sdk） 有附加说明，在linux下可以正常查看，在windows下可能会有部分乱码-err

节点是网络系统的基本控制单元，论文提出了一种基于CPLD和多处理器结构的控制网络节点设计方案，它能够提高单节点并行处理能力，其模块化结构增强了节点的可靠性。-node network system is the basic control unit, This paper proposes a CPLD-based and multi-processor control structure of the network node design, It can enhance single node parallel processing capabilities, its modular structure to enhance the reliability of the nodes.

深入浅出ARM7_LPC213x/214x EasyARM2131开发板 LPC2131工程模板 演示程序（C）-Easy LPC2131 development board ARM7_LPC213x/214x EasyARM2131 template demo project (C)