适合KS8695X，可以下载图像文件TFTP

linux启动的介绍文档，启动的基本流程-linux start introducing the document, start the basic flow

介绍一种基于摄像头的智能车自动控制器设计方案。以飞思卡尔16 位单片机为核心控制单元，使用红外光电传感器采集路径信息，控制智能车的舵机、驱动电机，实现智能车的自主寻迹行驶。 -Introduction of a camera-based automatic control of intelligent vehicle design. Based on Freescale 16-bit microcontroller as the core control unit, the use of infrared photoelectric sensor acquisition path information, control, intelligent vehicle steering gear, drive motors, autonomous intelligent vehicles driving tracing.

ucFS的加强版，并且含完整代码，希望对苦苦寻找UCfs全部源码的朋友能有所帮助-ucFS of the enhanced version, and with complete code

new 9200 uboot yf9200bd

有关的线路连接  GND – GND, VCC – 3.3V, CS – D8, CSN – D9, SCK – D10, MOSI – D11, MISO – D12, IRQ – D13 这个测试程序是发射端不断发送0x00到0XFF的数据给接收端

一个在ARM上通用的IIC的程序,已经测试用过了,-an ARM in the IIC common procedures, has used the test,

x5045用法，源码--Source code for using x5045.

ucos 移植实验成功把ucos移植到2410上建立十个任务，每个任务不停地往串口上打印自己的任务号-CENTER transplantation experiments successfully transplanted to CENTER 2410 on the establishment of 10 tasks, each task to keep serial printing its own mandate,

运算器的实现，即实验指导书中的实验一，文件中包含有原代码及端口设置（可变），用vrilog HDL编程，Xilinx ISE 6仿真，并在实际电路中得到实现．-operations for the realization of the experimental guidance of a book. document contains the original code and port settings (variable), with vrilog HDL programming, Xilinx ISE 6 simulation, and the actual circuit realization.

nec公司生产的78k系列的0547d的示例程序-nec produced 0547d series of 78k sample procedures