STCS89C51单片机的介绍，给热爱STCS89C51的朋友提供一个参考资料。...

这是一个基于P89c51单片机的声音与显示C51程序--A P89C51-SCM-based C51 program for sound and display.

由"晓风"编写的PLD入门的好教材：pld.rar（中文PDF文档）-from "feng" prepared by the entry PLD good material : pld.rar (Chinese PDF)

串行IIc总线型EEPROM24c02的读写汇编源程序，并由按键控制读写操作。-Serial Bus type IIc EEPROM24c02 compilation of source code to read and write, and write control buttons.

zlg sd card for ucos

自行车里程设计的远程序 他的用途很实际的 并且说明详细-bicycle mileage from the design process he uses a very practical and detailed note

由sEOS简化来得，应用于51的简单OS，主要是时间的管理，没有更多的功能，但是分实用-sEos by more simplified, for the simple 51 OS, is time management, no more functional, but the practical points

29个单片机实验（转载）-29 SCM experiment (reproduced)

硬盘、u盘、mmc、cd-rom mp3播放器源码-Hard drive, u disk, mmc, cd-rom mp3 player source code

LT_1B msp430开发板例子程序－TB5

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.