第二近轴光的实际参数.cpp 近轴光线计算

基于凌阳和ad9850实现的正弦波信号发生器程序，包含键盘、显示模块程序-Sunplus and the AD9850 based on the realization of the sine wave signal generator procedures, including keyboard, display module procedures

8051 SIMULATOR GOOD WORK

在keil-ARM环境下对ARM7处理器编译成功的I2C总线程序，程序通过I2C总线向UART串口发送数据，验证了I2C总线程序的正确性。-Keil-ARM in the circumstances of the ARM7 processor to compile the success of I2C bus procedures, procedures for the adoption of I2C serial bus to send data to the UART, I2C bus to verify the correctness of the procedure.

TM160 OCCWUGWA1 and uc1698资料和驱动程序-TM160160OCCWUGWA1 and uc1698 Driver

单片机驱动162芯片典型程序，简单明了。-Single-chip driver 162 chipset typical procedure, simple and clear.

用凌阳单片机作的一个语音程序，你可以将你的语音文件压缩之后加入到该程序里直接运行就可以阿！-Sunplus with the MCU for a voice procedures, you can document your voice compression by adding to the direct operation of the program will be A!

/* * Copyright (c) 2005,浙江联大仪表有限公司仪表技术部 * All rights reserved. * * 文件名称：oil level sensor over.c * 文件标识：无 * 摘 要：油位传感器最终版 * * 当前版本：1.1 * 作 者：翁德平 * 完成日期：2005年6月10日 * * 取代版本：1.0 * 原作者 ：翁德平 * 完成日期：2005年5月10日 */-/** Copyright (c) 2005, the United Nations General Assembly in Zhejiang Instrumentation Limited Instrumentation Technology* All rights reserved.** File name : oil level sensor over.c* identification documents : None* Abstract : Oil Level Sensor** The final version of the current version : 1.1* Author : Andr-* Date : June 10, 2005** replace Version : 1.0* Author : Andr-* Date : May 10, 2005* /

PROFIBUS SLAVE PROGRAMS PRO FIBUS SLAVE PROGRAMS

本PDF文件讲述了PIC单片机的入门知识,以及使用这款单片机应注意的问题及源码例程-This PDF document describes entry-PIC MCU knowledge, and the use of this single-chip should pay attention to the problems and source routines

使用80C51单片机与PC机进行通信的源程序，能够使用串口线实现电脑控制单片机外围设备-80C51 Microcontroller and PC use to communicate the source machine, to use computer-controlled serial lines to achieve single-chip peripherals