对初学者会有用。主要针对于西门子STEP7组态编程的实践程序。软件平台《step7v5.3》...

20*2液晶驱动程序，可以以总线方式或间接控制方式，注释清楚明了

基于MEGA16的走马灯实验，对初学者有帮助!! -Based on the lantern MEGA16 experiments, helpful for beginners!!

12864LCD显示控制 可以显示图形和动画-12864LCD display control can display graphics and animation

77E516的双串口演示程序,同样适用于77E58.双串口最佳示例代码-77E516 dual serial Demonstration Program, the same applies to 77E58. Dual Serial best sample code

常用串行EEPROM的编程应用，EEPROM是"Electrically Erasable Programmable Read-only"（电可擦写可编程只读存储器）的缩写，EEPROM在正常情况下和EPROM一样，可以在掉电的情况下保存数据，所不同的是它可以在特定引脚上施加特定电压或使用特定的总线擦写命令就可以在在线的情况下方便完成数据的擦除和写入-Commonly used application of serial EEPROM programming, EEPROM is Electrically Erasable Programmable Read-only (Xinhua EPROM) acronym, EEPROM under normal circumstances and EPROM, as in the case of power-down to save data , What is different is that it can exert in a particular pin on a specific voltage or use specific bus write command can be in the case of online data to facilitate the completion of the erase and write

8MHz，FLL+自动校准。

C语言 端口控制和中断控制 数据的读取 控制电磁阀-KEIL C byte_read sector_erase unsigned char byte_program unsigned char byte_program_and_verify unsigned char Compare

pROFIBUS 从站源程序 SPC3 pROFIBUS 从站源程序 SPC3 -PROFIBUS slave source SPC3 pROFIBUS source from the station SPC3

基于C8051F330的24c04测试程序 利用I2C接口直接对其读写-24c04 based on the C8051F330 the test procedure using I2C interface to read and write directly

PIC24单片机程序示例。 目前这方面的资料较少。自己先顶一下。-PIC24 Singlechip sample procedures. At present, less information in this regard. Their first top-click.