SCM can be used to do a universal remote control

单片机控制TC35I无线通信模块源程序 -SCM TC35i wireless communication module source

通过51单片机产生不同频率的信号，在喇叭上产生不同频率的声音信号，实现不同音乐播放-Through 51 different single-chip frequency signal generated in the speaker s voice signals at different frequencies, different music player

基于ARM7的U盘程序开发代码,可以-ARM7-based U-procedure code, can see the

多点烟雾,温度探测报警程序 基于MSP430F247,485总线.-More smoke and temperature detection alarm procedures based on the MSP430F247, 485 bus.

64点阵C程序有移动功能具有时间显示，可设置时间，断电保存-64 dot-matrix C procedures with mobile features the time display can be set-up times, power save

该程序用于控制电机的速度,通过占空比PWM来实现该功能.-The program used to control motor speed and PWM duty cycle to achieve through this feature.

内容： *红外测试程序，用单片机通过发射管发射38K的调制频率码，由一体化接收并解码由发光管显示。 *正常情况下，由于反射和高灵敏度接收，LED4（P1.3)一直闪烁，可以用黑色纸片完全遮挡接收头使 *之不能接收到发射管的信号，这是LED4熄灭。说明功能性正常 -Content:* IR test program, launched with the microcontroller through the launch tube of the modulation frequency of 38K code, by the integration to receive and decode from the LED display.* Under normal circumstances, due to reflection and high-sensitivity receiver, LED4 (P1.3) has been flickering, you can completely block the black pieces of paper to make* that they are not receiving the first emission control signal is received, it is LED4 out. Note the normal functional

12864液晶显示程序，msp430f149单片机控制-12864 LCD process, msp430f149 SCM

双机通信过程中采用点对点通信的主机部分示例-Two-machine communication process used in peer-to-peer communications in the host part of sample

一个用ATMega88来实现一key键和一个Rotor的代码，可能过UART上传数据。-A key with ATMega88 to achieve a key and a Rotor code, may be to UART upload data.