51上运行UCOSII，你要是想移植，但是不会，可以看看，有启发

Keil C Proteus 联合仿真的VDM51_dll文件.rar-Keil C Proteus 联合仿真的VDM51_dll文件.rar

是基于c8051f040单片机开发的电机转速测试程序。-SCM is based on c8051f040 test procedures developed by the motor speed.

基于AVR单片机mega8的电表c源程序（第四部分，红外收、发过流判断及其他）-Based on the AVR Microcontroller mega8 meter c source code (Part IV, infra-red close, hair over-current judgments and others)

c8051f340 USB传输 固件驱动， c8051f340 USB传输 固件驱动，-transmission c8051f340 USB drive firmware, c8051f340 USB transmission firmware-driven,

摩托车报警器源程序 　　　　　　　　　　　　　　　　　　 可以参考一下，程序是完整的-Motorcycle Alarm source can reference. process is complete

串口模拟程序，与电脑联机使用，使用51单片机。-Serial simulation procedures, and computer on-line access, the use of single-chip microcomputer 51.

自己编写的凌阳SPCA61A与SPCA563A图象识别模块连接驱动程序，带有4*8液晶显示驱动程序，开发环境unSP IDE 2-themselves prepared and Sunplus SPCA61A SPCA563A Image Recognition Module Link driver,* 8 with four LCD driver, development environment IDE 2.0.0 unSP

一个简单的程序，但是是我入门的时候写的，还不错-a simple procedure, but it is when I start to write, but also good

根据示波器的原理最做的代存储和显示的简易装置-oscilloscope under the principle of doing the most generation storage and display of simple devices

KeilC开发,51通过8255对外部4*4键盘进行控制.按键分别为0-9以及上下左右,加上确认取消.-KeilC development through 8255 to 51 4* 4 external keyboard control. Keys were 0-9 and above and below, coupled with canceled.