系列51单

点阵数码的驱动 例子显示“欢迎光临” 左右和上下交替显示-Examples of the digital dot-matrix driven displays " Welcome to" turn around and up and down display

针对USB2SPI128芯片的上位机驱动程序的源代码，主要是联通PC机的底层USB驱动和下位机单片机的通讯。-USB2SPI128 chip host computer for the driver source code, mainly to China Unicom PC-bottom USB drive and the next crew microcontroller communications.

斜度测试程序 * 程序对应的硬件设置为：利而达MSP430-Test44x实验板，斜度计使用的 * 是ADXL202E，数字y连接TA1/P1.2,数据x连接P1.0/TA0,P4.6对应斜度计电源 * 每个方向的斜度显示时都占用三个字符， * 斜度范围为0~90,高于90的，斜度为(180－斜度）-Gradient procedures for the corresponding test procedures* for the hardware set up: Lee MSP430-Test44x of the board, of the use of gradient is the* ADXL202E, the number of y connecting TA1/P1.2, data x connect P1.0/TA0, P4. gradient of 6 corresponds to the power* of the gradient in each direction are occupied by shows that the three characters,* angle range of 0 ~ 90, more than 90, and slope for the (180- angle)

eeprom24c02程序代码，经测试可以使用，分享一下-eeprom24c02 program code, have been tested can use, share

读写C8051F020内部FLASH的代码-Read and write code C8051F020 internal FLASH

sja1000驱动源代码-sja1000 driver source code

串行芯片595单片机接口，用于led显示的c语言程序-595 chip microcontroller serial interface for the show led c Language Program

使用AT89C52单片机，12MHZ晶振，P0口读入AD值，P2口作AD控制，用共阳LED数码管， P1口输出段码，P3口扫描，最高位指示通道（0-7）。-AT89C52 single-chip microcomputer use, 12MHZ crystal, P0 I read into the AD value, P2 for the AD population control, with a total of Yang LED digital tube, P1 port output above code, P3 port scan, the maximum bit instructions channels (0-7).

MSP430 F149的单片机 TimerA驱动程序，便于相应计时器的操作-MSP430 F149 microcontroller TimerA drivers, to facilitate the operation of the corresponding timer

数字电路抗干扰： 在电子系统设计中，为了少走弯路和节省时间，应充分考虑并满足抗干扰性 的要求，避免在设计完成后再去进行抗干扰的补救措施。-Digital circuit interference: In the electronic system design, for less detours and save time, should take fully into account and meet the requirements of anti-interference, to avoid later in the design of anti-interference to carry out remedial measures.