基于ucos

nRF9E5的性能测试程序,该程序控制开发板的一个灯的亮与灭.-nRF9E5 the performance test procedures, the control of a development board with the bright lights out.

本系统参照片上系统的设计架构、采用FPGA与SPCE061A相结合的方法，以SPCE061A单片机为进程控制和任务调度核心；FPGA做为外围扩展，内部自建系统总线，地址译码采用全译码方式。FPGA内部建有DDS控制器，单片机通过系统总线向规定的存储单元中送入正弦表；然后DDS控制器以设定的频率，自动循环扫描，生成高精度，高稳定的5Hz基准测量信号。-The system with reference to the design of system-on-chip architecture, used a combination of FPGA and SPCE061A approach to SPCE061A Singlechip for process control and scheduling core mission FPGA for external expansion, internal self-system bus, address decoding using the entire translated code approach. DDS has built internal FPGA controller, microcontroller through the system bus to the provisions of the storage unit into the sine table DDS controller and then to set the frequency, automatic cycle of scanning, to generate high precision and high stability of the baseline measurement 5Hz signal.

对4x4键盘进行扫描并将结果送数码管显示

是一个用8051＋ds12887的代码程序，程序中有很详细的说明，可以拿来稍做修改就能使用。-is using a 8051+ ds12887 code procedure is a very detailed explanation can be used to make slight changes can be used.

在现代电子系统中，有为数众多的IC需要进行相互之间以及与外界的通信。为了提供硬件 的效率和简化电路的设计，PHILIPS开发了一种用于内部IC控制的简单的双向两线串行总线I2C-In modern electronic systems, there are a large number of IC need each other and communicate with the outside world. In order to provide the efficiency and simplify the hardware circuit design, PHILIPS developed an IC for internal control, a simple bi-directional two-wire serial bus I2C.

c51MAX232通信子程序-c51MAX232 communications Subroutine

无线传感器网络leach协议 无线传感器网络leach协议-WSN LEACH protocol

AVR M16单片机AD转换测试程序，ICCAVR编译，测试通过，-M16 AD converter testing procedures ICCAVR compile, test,

基于AD9850的数字信号发生器c51原代码。编译通过。-based on the AD9850 digital signal decoder source code generator. Compile.

51单片机模拟解码2272程序，此方法较硬件解码要方便而且灵活性要强，可靠性也得到加强。-51 2272 microcontroller decoding process simulation, this method than hardware decoding to facilitate flexibility and stronger, Reliability has also been strengthened.