STM32

实现Gabor滤波的源代码，包括C++、matlab源程序，还有介绍其原理的word文件(Gabor filter realization of the source code, including C++, matlab source, as well as introduce the principle of word document)

应用于fluent的UDF程序，用于修正液滴表面轮廓(The UDF is applied fluent procedures for correcting the droplet surface contour)

上电后,在BRAKE信号无效,且保护逻辑无输出的情况下? 电机按DIRECTION信号的方向转动? 电流传感放大器采样电机电枢电流,经13脚的RC网络转换为电压值,与D/A转换输出的预定阀值相比较。如果当前的电流使转换的电压值小于阀值?(Power after the BRAKE signal is invalid, and the protection logic no circumstances ? electrical output signals according to the direction of rotation DIRECTION ? current sensing amplifiers motor armature current sample by 13 feet of RC network is converted to voltage value, and D/A conversion output compared to the target threshold. If the current of current to voltage conversion value is less than threshold ?)

【实例简介】CAN通信实验

在数学建模比赛中要获得好的分数，最好都要进行灵敏度分析。本文件中包含详细的matlab灵敏度分析程序，只要通过修改相关参数即可。(In mathematical modeling competition to get a good score, the best sensitivity analysis should be carried out. This document contains a detailed sensitivity analysis matlab program, simply by modifying the relevant parameters.)

IEEE standard Common Format for Transient Data Exchange (COMTRADE) for power systems.pdf电力系统故障录波的标准数据格式(IEEE standard Common Format for Transient Data Exchange (COMTRADE) for power systems.pdf power system fault recorder standard data format)

一个用FTT法实现相关函数的快速估计程序(A correlation function with the FTT method to achieve the rapid estimation procedures)

GSM信道估计，c实现，包含详细的报告说明，很全。(GSM channel estimation, c achieve, contains a detailed description of the report, it is.)

说明：  恩智浦智能车竞赛程序框架，用于学习和参考(NXP Smart Vehicle National First Prize Program)

【实例简介】 c#与西门子s7-200 smart 通讯实例 内附S7TCPDLL.dll 【使用说明】 在bin文件夹debug，config文件打开配置PLC IP地址，CPU 的信息 修改配置文件 [PlcComTCP] IP=192.168.0.1  //PLC IP地址 Rack=0          //PLC 机架 Slot=1          //PLC 插槽 注，PLC和电脑 IP必须在同一网段 S7TCPDLL使用方法 1）添加引用，然后倒入命名空间 using S7TCPDLL; 2)实例化函数 S7Client 例如：   S7Client client = new S7Client(); 然后利用VS开发平台智能感知的功能可选择相应函数 例如调用置位函数 SetBitQB(0, 0)        首先实例化函数S7Client client = new S7Client();        然后 client.SetBitQB(0, 0); 调用其他函数类似。