是一个G代码转换的源程序，将标准G代码读入后在UG环境下生成加工代码刀具路径。...

电子图书《华中理工大学出的C51教材》，很不错的。-electronic books "Huazhong University of Science and the C51 materials," very good.

C51 用PCA 模拟串口，很有参考价值得源码-C51 with PCA serial analog, a valuable source

摩托车的步进电机驱动。用的是LPC900系列单片机的RTC定时器，虽然简单，但足以说明问题。-motorcycle stepper motor driver. The LPC900 Series is the RTC timer, although simple, but enough to illustrate the problem.

台电T50电路图，用于研究T50的电路设计，以及Rk2706的共模设计方案-Taipower circuit T50, T50 for the study of circuit design, as well as the common-mode Rk2706 design

控制电机运动的G代码程序,如果对G代码不清楚,请先看懂G代码,然后再看本程序

C51 串口通信 包括解析报文-C51 Bunches of communication include the message translating

利用PWM产生高精度正弦波,从PWM引脚输出的脉冲信号经过简单的低通滤波后,可以得到平滑的正弦波,波的频率可以微调-produced using high-precision sine wave PWM, PWM output pin from the pulse signal through simple low-pass filter, can be smooth sine wave, the wave frequency can be fine-tuned

uip源代码（for 8/16位单片机）-East source code (for 8/16-bit microcontroller)

单片机的程序，欢迎探讨-Microcomputer Program, welcomed the study

62256c语言读写程序，经过验证，可以直接使用-62256c language reading and writing process, after authentication, direct access to