三菱梯形图转成51单片机HEX文件。
三菱软件写好梯形图,再运行转换软件,设定好51单片机的输入输出,
打开写好的梯形图,转换出的就是hex文件,烧录到...
三菱梯形图转成51单片机HEX文件。
三菱软件写好梯形图,再运行转换软件,设定好51单片机的输入输出,
打开写好的梯形图,转换出的就是hex文件,烧录到51单片机,51单片机
就可以执行PLC的动作了。51单片机控制板价格便宜,可以代替简单场
合的PLC,控制成本降低。
1:把PWM转换后,在PWM文件下生成一个HEX文件。
2:生成的文件很大,51单片机要选用8K以上(AT89S52就是8K)储存量的。
3:把HEX文件下载到单片机就可以用了。
-Mitsubishi ladder into 51 single-chip HEX file. Mitsubishi software written ladder, and then run the conversion software, set 51 single-chip input and output, open ladder-written, conversion is a hex file, burn to 51 single-chip, 51 single-chip microcomputer can be implementation of the action of PLC. 51 Single-chip panel prices, can replace the simple occasions PLC, control and lower the cost. 1: after the PWM converter, PWM documents generated in a HEX file. 2: generate a lot of paper, 51 single-chip 8K to choose more than (AT89S52 is 8K) storage capacity. 3: The HEX file can be downloaded to a single-chip microcomputer used.
- 2022-09-07 14:30:03下载
- 积分:1
充分实现
uart全功能实现.实现如下函数:
U_Open,
U_Close,
U_GetBytes,
U_PutBytes,
U_GetBytesAvail,
U_GetTxRoomLeft,
U_PutISRBytes,
U_GetTxISRRoomLeft,
U_Purge,
U_SetOwner,
U_SetFlowCtrl,
U_ConfigEscape,
U_SetDCBConfig,
U_CtrlDCD,
U_CtrlBreak,
U_ClrRxBuffer,
U_ClrTxBuffer,
U_SetBaudRate,
U_SendISRData,
U_SendData,
U_GetOwnerID,
U_SetAutoBaud_Div,
/*TY adds these to expand flexibility 2004/10/15*/
U_Register_TX_cb,
U_Register_RX_cb,
/*TY adds these to let virtual COM port can retrive exception log 2005/3/8*/
U_GetUARTByte,
U_PutUARTByte,
U_PutUARTBytes,
/*for virtual com port to return DCB configuration*/
U_ReadDCBConfig,
U_CtrlRI,
U_CtrlDTR,
U_ReadHWStatus -the realization of full-featured UART. to achieve the following functions: U_Open, U_Close, U_GetBytes, U_PutBytes, U_GetBytesAvail, U_GetTxRoomLeft, U_PutISRBytes, U_GetTxISRRoomLeft, U_Purge, U_SetOwner, U_SetFlowCtrl, U_ConfigEscape, U_SetDCBConfig, U
- 2022-01-31 05:01:21下载
- 积分:1