430AD实验并有液晶驱动资料,已实验通过,请放心下载

用中断的方式控制lcd的显示，单片机仍然是h83664十六位单片机。此程序包含单片机的接口的配置以及各种写lcd的子程，使用中断来控制lcd顺序显示A－Z，当然，可以换成其他的显示内容，由于接口程序已经编好，只需要把要显示的内容改一下就可以实现其他内容的显示-With interruption control lcd display, single-chip is still 16 Singlechip h83664. This procedure includes the configuration of single-chip interface and a variety of writing a sub-lcd-way, the use of interrupt to control the order in lcd display A-Z, of course, can be replaced by other display content, as a result of interface procedures have been developed only to To display the contents of change can be achieved about the display of other content

AVR Programme is a SPI Example

8位LED显示驱动芯片MAX7219的驱动程序-eight LED display driver chip MAX7219 driver

c语言写的des(430单片机) 用430单片机实现的DES加密系统-c des written language (SCM 430) 430 MCU with the DES encryption system

keil51使用中文详解-keil51 Comments on the use of Chinese

关于MAX7219与TLC2543的数据采集系统-on MAX7219 and TLC2543 Data Acquisition System

液晶显示器rt12232的AVR程序，显示程序例子。-LCD rt12232 of AVR procedures, examples of display program.

单片机设计的遥控电路，遥控码的脉宽数用红外线接收器解码后送单片机读入，发射时由单片机产生40KHZ红外调制信号送红外线发射管发射-Single-chip design of the remote control circuit, remote control code number of the pulse width decoder using infra-red receiver to read single-chip evacuation, launch generated by single-chip modem 40KHZ IR signal sent to the launch tube fired infra-red.

This code implements the basic functions for an I2C slave device using the SSP module. All I2C functions are handled in an ISR. Bytes written to the slave are stored in a buffer. After a number of bytes have been written, the master device can then read the bytes back from the buffer.

ISP1581_USB2.0各工作模式的测试程序，对学习很有帮助！-ISP1581_USB2.0 the working mode of testing procedures, very helpful!