该程序是基于51

AVR定时器功能 定时器每秒加一,0到255循环,通过数码管显示计数值-AVR timer function Timer per second, plus one, 0 to 255 cycles, through the LED display counts

锅炉水位模拟系统。由两排各125个小LED灯组成，可以让小灯从任意位置在任意时刻移动到目标位置。-Boiler water level simulation system. By two rows of the 125 small LED lights that can allow a small lamp from anywhere at any time move to the target location.

51单片机对 siemens4442卡的底层驱动程序 把.rar改成.C即可-51 Singlechip siemens4442 card on the bottom of the driver. Rar changed. C can be

学习例程，共有100例，测试成功，在此上传工大家学习提高-Learning routines, a total of 100 cases, testing the success of workers in this upload them to learn to improve

可编程逻辑器件在数字式抢答器中的应用 -Programmable logic devices in digital Answer Explorer Application

这篇实验报告是关于单片机多路数据采集的，本实验由2大部分组成：1、为用EPOROM构成的心电信号发生器；2、为多路信号的微机采集与显示；第一部分实验主要研究可编程序存储器EPROM的非计算机应用。把存储在EPROM中的数字心电信号读出并通过D/A转换为模拟信号显示在示波器屏幕上。 第二部分实验的目的是研究一个数据采集系统，该系统利用ECD-51型单片机为中心，由D/A芯片等将各种低频信号以及由EPROM产生的模拟人体心电信号变换成离散的数字信号存入微机内存，以待进行数据处理和分析，然后再通过D/A转换将其还原成模拟信号显示在示波器的屏幕上。 -This experimental report on the multi-SCM data acquisition, the experiment by the two major components : 1. EPOROM pose for the use of the ECG signal generator; 2, multi-path signals in the computer acquisition and display; the first major study of experimental programmable EPROM memory in non-computer applications. Stored in the EPROM of ECG read out by D/A conversion of analog signals displayed on the oscilloscope screen on. Part II The purpose of this experiment is to study a data acquisition system, which uses ECD-51 microprocessor as the center, from the D/A chips, and other various low-frequency signal from EPROM and the simulation of human ECG transform into several discrete signal words into computer mem

ds时钟芯片编程 对ds时钟芯片进行设置时间，读取时间等的操作-ds clock chip programming right ds clock chip for set-up time and the time to read the operation

用C语言编写的PIC单片机一些例程源代码，很有参考价值。-C language prepared by the PIC source code of some routines, great reference value.

电平转换芯片资料，串口与单片机通讯应用，转换后电压在0-5之间-Chip-level conversion data, with the single-chip serial communications applications, the conversion after the voltage is between 0-5

SPC3 PROGRAMS SP C3 PROGRAMS