利用8051单片机驱动MAX038信号发生模块，实现信号发生器功能。...

keil c51 小模式下uc/os应用，版本keil uv2 6.12，很好用-decoder mode uc/os application, version 6.12 Keil uv2 good use

51单片机键盘的相关处理，按键扫描，后针对具体应用进行相应处理．-51 Single-chip related deal with the keyboard, keypad scanning, after the specific application of the corresponding treatment.

STC89C58RD+系列软件实现多串口-STC89C58RD+ Series software multi-serial

16*2液晶显示驱动程序，包含字符输出和字符串输出函数，可直接使用-16* 2 LCD driver output and the string contains the character output function can be used directly

这是一个单片机c51多功能电子表程序，附带说明文档（包括硬件连线图，流程图等），绝对原创-This a multi-purpose microcontroller decoder electronic form, along with documentation (including hardware wiring diagram and flowchart), absolute originality.

有关网络接口芯片RTL8019As论文，有助于这方面的开放-The network interface chip RTL8019As papers, help in this regard open

8253的初始化程序举例: 例1：选择2号计数器，工作在3方式，计数初值为533H（2个字节），采用二进制计数。其初始化程序段为 MOV DX，307H ；命令口 MOV AL，10110110B ；2号计数器的初始化命 令字 OUT DX，AL ；写入命令寄存器 MOV DX，306H ；2号计数器数据口 MOV AX，533H ；计数初值 OUT DX，AL ；选送低字节到2号计数器 MOV AL，AH ；取高字节送AL OUT DX，AL ；后送高字节到2号计数器 -8253 initialization procedures examples : Example 1 : Select counters on the 2nd, in three ways. Counting for the initial 533H (2 bytes), a binary counting. Initialization of its procedures for MOV DX, 307H; I ordered MOV AL, 10110110B; on the 2nd Counter initialize command word OUT DX, AL; write commands Register MOV DX, 306H; data on the 2nd Counter I MOV AX, 533H; Counting initial OUT DX, AL; low-byte sent to the 2nd Counter MOV AL, AH; With a high-byte send AL OUT DX, AL; evacuations high byte counter to the 2nd

用单片机实现对温度的测量，并在数码管上显示出来，精度很高-Achieved with single-chip temperature measurement and control in the digital display, high accuracy

基于51系列单片机的超声波测距壁障程序 采用4位共阴数码管显示-51 Series single-chip microcomputer-based ultrasonic ranging barrier procedure used a total of four digital tube display Yam

凌阳单片机的串口通信程序，在SPCE061A芯片上调试通过-Sunplus Single-chip serial communication procedures, in SPCE061A chip debugging through